Gargoyle Forum

Anyone got a screenshot of a working Wireless Bridge/Repeater setup?

I never get DHCP and even if I manually set the client, there is still no access to the gateway (via cabled client or wireless client).

The bridge is still accessible from the gateway side.

Hello i hope you can help me? how i do this setup TFTP set PC to 192.168.0.66 /255.255.255.0 by using Windows 10 i have flash the wrong gargoyle firmware on my TL-WR941ND v6 Hi, sorry I couldn't provide any help for you as am not using Win10. There should be some youtube guides for setting up TFTP ...

dodgy card or cable (maybe lan port but doubt). Dont think a Gargoyle issue.

Eliminate hardware issues...different port on the router?

Hi Tapper, The Gargoyled bridge unit is a 1043ND v2, connected to an ENGENIUS ESR1221N2 300mbps wireless router(factory firmware) set to B+G+N mode. 1043NDv2 Tested under 1.8.1, 1.9 and 1.9.X (Built 20160103-1917 git@5b7c763) I don't see whether you have repeater enabled (like me) in your bridges, a...

1.9.X (Built 20160103-1917 git@5b7c763) Model:TP-Link TL-WR1043N/ND v2 Still fails in wireless bridge-repeater. Works for a few minutes ..sometimes slow to access the router...then eventually clients lose network access completely. Also, plugins..could not install LOG READ...click install but after ...

Will try. Bridge is a disaster in 1.8.1 and 1.9 on a 1043NDv2. * strangely (when it was stable) only non-Windows devices could successfully get and retain from DHCP (wireless clients). I tried 3 diff laptops (win7, win.81, win10) and all would not hold network settings. If I manually set, it would s...

I noticed there are two separate networks, insulated from one another: the one with the devices connected to the main router and the devices connected to the TP-LINK, but for my current needs is not a problem. So this is the same as just setting up as GATEWAY with connect via DHCPor Static Wireless...

Recovered to factory. Can do without serial port. setup TFTP set PC to 192.168.0.66 /255.255.255.0 get correct recovery file from http://www.friedzombie.com/tplink-stripped-firmware/ ensure for v6 !! rename recovery file to: wr941ndv6_tp_recovery.bin Connect PC to WAN port (eth0) of router. Power on...

Mistake was presuming that if the GARGOYLE firmware is listed for that specific version then it is supported.

Shouldn't the ver6 firmware be removed???

I couldn't get 1.8.1 working on a 1043ND v2 either. It initially seemed to work then died quickly. Clients could not DHCP nor could ping anywhere. Even could not reach the Gargoyle webui.

Had to set as Gateway with Internet/Wan via wireless link instead.