Gargoyle Forum

I thought I turned it off, it must have turned back on because of the bug you mentioned, because I usually set the range from 10 to 200 and it was set from 100 to 150. This might prove the bug I was reporting though, DHCP was turned on, but it didn't seem to conflict with my main router, therefore i...

Like I said, I've already reconfigured the router as an access point, but here are the current config files: Network: config interface 'loopback' option ifname 'lo' option proto 'static' option ipaddr '127.0.0.1' option netmask '255.0.0.0' config globals 'globals' option ula_prefix 'fda5:8779:81ef::...

The host computers and other devices don't get assigned an IP address, DNS, and default gateway, they are blank. I need to assign a static IP from the host machine just to connect to the router's network.

I've been having this issue with my TP-Link TL-WR1043N/ND v2 running Gargoyle 1.12.0 where the DHCP service is enabled but doesn't distribute IP addresses after losing power. Whenever we have a power outage or if I turn off the router the DHCP service stops working but remains enabled in the setting...

I'm having a very similar problem. I posted about it here:
http://www.gargoyle-router.com/phpbb/vi ... =11&t=6715

What version of Gargoyle are you running? 1.7.0?

Alright, thanks.
I guess I'll downgrade to 1.6.2 and see if that works.
UPDATE: Yup, that did the trick, thanks again.

I bought a TP-Link TL-WR1043ND v2 about a month ago and replaced the firmware with Gargoyle v1.7.0, I got everything up and running fine until 3 days ago where the internet connection kept dropping. I'd have a connection for 2-5 seconds, then it would drop for 1-20 minutes and kept doing that over a...