Gargoyle Forum

I am having the same problem reported here for 1.9.2 with my installation of 1.12.0 on a TL-WDR4300. It has turned on its DHCP several times spontaneously, and I have had to turn it off again because it is daisy-chained with another (gateway) router connected to my cable modem. The gateway router is...

Thanks for all of the suggestions. As it turns out, none are relevant. In v1.12.0, the setting "Wireless Client Isolation" for the primary (not guest) network under "Connection - Basic" prevents clients both cabled and wireless) from receiving IP addresses via DHCP from a gateway...

Thanks to both of you for your responses. I'm not sure what is meant by a "clean start", but the typo was in my post, not in the configuration. As far as "plugging everything in correctly" is concerned, nothing in the cable connections was changed from the working configuration w...

i have similar problems since updating from v1.8.1 to v1.12.0. I did not attempt to presere settings but instead saved the setup pages from the v1.8.1 configuration and attempted to reproduce them manually in the v1.12.1 configuration. The Gargoyle router is connected to the gateway (or as some in t...

I am a little confused. I have two TL-WDR4300s, one running Gargoyle 1.8.1 and one running TP-LINK's firmware. TP-Link claims that routers running in the normal AP or router nodes are not vulnerable to KRACK. Is that so? How can it be? The reason I ask is that I prefer not to install firmware from t...

under "Connection->Device Configuration", you should choose "Wireless Bridge/Repeater". under "Connection->Wireless Bridge/Repeater", you should choose "Bridge to LAN" and "Repeater Disabled". This appears to disable the 5 GHz band; I only get setti...

I'm too ignorant to fully understand the implications of this, but it sounds as though it might solve a problem I have. I have two routers to cover my apartment adequately. Obviously, only one has DHCP enabled. This is the "master" router, which is connected to the WAN. The guest network o...

Well I gathered up my courage and upgraded directly from 1.5.10 to 1.6.1. with "attempt to preserve settings". I had a little trouble with a shared USB drive, which gave me "error: illegal address" when I tried to edit its configuration. Apparently 1.6.1 expected to find a vaiid ...

The changelog http://www.gargoyle-router.com/wiki/doku.php?id=changelog#v1511_tue_oct_15_2013 says that 16M flash is required for the webcam plugin. Unfortunately, TP-Link http://www.tp-link.com/lk/products/details/?model=TL-WDR4300#spec doesn't say how much is in my WDSR4300, but openWRT http://wik...

I used the "factory" image to upgrade from the stock firmware to 1.5.11, then the "sysupgrade" image for subsequent upgrades. I plan to sysupgrade my TL-WDR4300 (v1.3) from 1.5.10 to 1.6.1. Did you backup your 1.5.11 settings and restore them under 1.6.1, or did you configure ev...