Gargoyle Forum

Just to report I have similar problem on an Asus 520gu, upgraded to 1.3.5 (from 1.2.3), I could add quotas but I couldn't add shaping, kept trying various options, apply/save and it wouldn't stay. I reset to default, reflashed and reset again and still same. Also, not sure if it's relevant but the r...

Maniac - I've set the modem to bridge mode only, and the Router to PPPoE (wired). The internet works, and port forwarding works. I'm not able to reach my modem at all though, but the only reason I need to be able to access my modem is to check my sync speeds at line rates. Is there a way to do this...

Yep same here, was doing it on 1.06, 7, 8,
PPPoE wouldn't start until I went to the page and just saved settings without changing anything, then it connected and got IP
I have not updated yet to latest to test that

In Gargoyle no, Tomato, yes. Though NTFS support isn't very good, you'll need to install separate NTFS read/write modules. Having said that it's really not advised, much better off with Fat32 if you have to but preferably Ext2/3 See: http://www.linux-ntfs.org/doku.php http://www.linksysinfo.org/foru...

Small thing really, not that important but I notice that when restoring configs that [Web Login Session Length] always seems to default back to 15mins, Maybe it's meant to do that seems odd that everything else I set up under Web Access stays there though.

Hi, just started to test out and use this excellent looking firmware but I haven't found a definitive answer to this. Most other (DD-WRT, Tomato) i used doesn't usually advise to restore config from earlier version when updating to new ones, Gargoyle is different? Realise that it doesn't use NVRAM f...