Gargoyle Forum

Just updated my aging wndr3700v1 for a new v4. I'd love to see Gargoyle support for it in the future.

Anyone else?

Sue, do u know which version of this router that u have? In my case I have v1. I had to go back to stock firmware for the time being. Ddwrt firmware does the same thing. No WAN/Internet ip can be pulled. Edit: never mind I see in your picture u have the v2. So far this problem has been only reported...

This is a common problem with no solution at the moment.

Try to downgrade to the oldest stock firmware you can find for your v2 and then try my trick again.

Just rename the gargoyle firmware img to mimic the stock firmware filename and it should work fine..

Is gargoyle 1.5.9 using latest trunk build? This is the one I tried.

I'm back on stock now

Nirajshah7, please let us know how it goes! Thanks man

Lingula wrote:Did you reboot the modem?

Yes, reset to defaults and unhooked it from power for hours.

I have the same issue with my netgear wndr3700 with a Comcast docsis 3.0 modem also.

Can't figure it out

This is how I did it on my wndr3700.. Hold reset for 30+ seconds under power LED flashes green. Open command prompt. tftp -i 192.168.1.1 put WNDR3700-V1.0.78.9.img Substitute the name of the image file with the one u have. Make sure u issue the tftp command while in the same directory as the image f...

Same problem here on my wndr3700 v1. This is with a Comcast cable modem. It's been reset to defaults, unplugged for hours and still no luck. DDWRT also does the same thing. No issues with WAN port on stock firmware. When I put the router into recovery mode by holding the reset for 30+ seconds (I'm n...