Gargoyle Forum

Ok, I successful connect with wireless DHCP after router reflash. I think that is not problem with network config oraz wireless, because Gargoyle get now ip address form wirless DHCP and on ssh connection from router console I can ping any internet host. But no pings from any Lan host to internet. F...

Wireless DHCP client: root@OpenWrt:/# uci show network network.loopback=interface network.loopback.ifname=lo network.loopback.proto=static network.loopback.ipaddr=127.0.0.1 network.loopback.netmask=255.0.0.0 network.lan=interface network.lan.type=bridge network.lan.proto=static network.lan.netmask=2...

Static WAN config: root@OpenWrt:/# uci show network network.loopback=interface network.loopback.ifname=lo network.loopback.proto=static network.loopback.ipaddr=127.0.0.1 network.loopback.netmask=255.0.0.0 network.lan=interface network.lan.type=bridge network.lan.proto=static network.lan.netmask=255....

Successful build with Gargoyle and successful booting Web Gui works, new login page, all pages from menu load correct, even Save button works. All LAN services too. Wi-Fi was disabled default and need first enter configuration by console to /etc/config/wireless. Then wireless get enable Gargoyle. Al...

Hmm. Board is RB411A with Wistron CM9. Webgui LuCi full working. In first time with mistake I install packages from: src/gz snapshots http://downloads.openwrt.org/snapshots/trunk/ar71xx/packages src gargoyle http://gargoyle-router.com/packages/kamikaze0709/atheros-2.6 ....and Gargoyle web gui was pr...

New log from reflash: root@OpenWrt:/# opkg update Downloading http://downloads.openwrt.org/snapshots/trunk/ar71xx/packages/Package s.gz Connecting to downloads.openwrt.org (195.56.146.238:80) Packages.gz 100% |*******************************| 156k 00:00:00 ETA Inflating http://downloads.openwrt.org/...

I check the uci libs: root@OpenWrt:/# opkg install libuci Package libuci (0.7.1-1) installed in root is up to date. root@OpenWrt:/# opkg install uci Package uci (0.7.1-1) installed in root is up to date. root@OpenWrt:/# opkg install libmatrixssl-nothread Package libmatrixssl-nothread (1.8.5-1) insta...

Ok, some install results from logs. Any idea how to install it correctly? root@OpenWrt:/# opkg install gargoyle Installing gargoyle (1.0.0-3) to root... Downloading http://gargoyle-router.com/packages/kamikaze0709/atheros-2.6/./gargo yle_1.0.0-3_mips.ipk Connecting to gargoyle-router.com (64.130.10....

Hello, It is possible to add support for Atheros AR7130 boards in Gargoyle? I can success install LuCI src. System: Atheros AR7130 rev 2 (id:0xa8) Processor: MIPS 24K V7.4 Load: 0.00, 0.01, 0.00 Memory: 60.93 MB (11% cached, 0% buffered, 79% free I don't test yet if Gargoyle will run but i see only ...