Gargoyle Forum

here is printscreen

Yes, the boot on last line stop and starts again from the beginning

New problem. I connected to the router via serial USB TTL. In Putty I see this report exist any way to fix this bug?

I'm winer:) The router is now corect. Here is my instruction: 1) On your PC manualy change IP address to 192.168.1.2 and mask 255.255.255.0. Conect cabel between your PC and router (only to LAN port, not WAN) 2) see this video: http://www.youtube.com/watch?v=GVIrpJVebyE ... after turn on press butto...

It is a challenge:)

So I connect serial TTL USB cable. I understand and than I use IP router address to send BIN file with firmware? It is true?

I don't understand what you mean with USB cable. Can you detailen describe your solution?

If I reset the router the DHCP setting didn't change.

to: jorgemiguel4
It didn't help

I wrote to support and no answers :-(. There are probably only a limited number of solutions: 1) What password are still set when reset? Password as the password, admin, etc, it is not. 2) Does anyone know of a way to upload a BIN file through a web interface without logging in? 3) Does anyone know ...

I too...TFTP and telnet not connected. SSH connected but login is too impossible. Please any solution?

Hello, I have TP-link 1043ND with Gargoyle v. 1.5.8 (gargoyle_1.5.8-ar71xx-generic-tl-wr1043nd-v1-squashfs-factory.bin). Yesterday, I had to use the reset button. I thought that with all values ​​set to defaults. But it did not happen. Network settings (IP address + DHCP settings) remains the same, ...