Gargoyle Forum

No luck yet. The watchdog is the issue. There is a script that needs to be included.

http://robin-mesh.wik.is/Howto/OM1P_Ope ... e_Watchdog

But not sure how to accomplish it in Gargoyle.

I found this workaround on dd-wrt forums http://www.dd-wrt.com/wiki/index.php/OM1P_config

But I need to find out any suggestions to adapt it to get gargoyle on these routers.

Thanks

Anyone successfully got Gargoyle on OM1P's to work properly? I have a couple OM1P's and need the detailed QOS options that are on Gargoyle and not presently on Open Mesh.

Thanks

Hello wasn't aware that they must be the same hardware. I had one on a linksys 54GL and the other an atheros. Thanks and yes I did pair the mac addresses and the linksys saw it as a wds device but when I connect to the ethernet port in the atheros in the next room I did not get an ip via dhcp.

Hello, I loaded the latest bleeding edge update and got the WDS mac pairing to work however I'm not getting an ip via dhcp on the ethernet interface of a MR3201A from the master. I tired click the routing tab but it's hanging. I saw no option of putting an ssid in the repeaters. Will the ssid of the...

When you finish flash try putting a static ip in your pc's nic e. 192.168.1.100 and 255.255.255.0 and then try ping 192.168.1.1 which is the router. If successful then open your browser and go to the ip 192.168.1.1. Then turn on DHCP in the router. I have had incidents where the router DHCP server i...

An update. I tried the AP51 flash utility and same result. Lose all access to the router and it's stuck somewhere in boot up stage.

Abe

I used the fon flash.

When I flash the router I can't get into it. Put in a static ip on my nic and tried to ssh or telnet into it @ 192.168.1.1 and no response. Pings return a hardware error.

Used open-mesh flash and it came back using their flash.

Abe

The open-mesh OM1P routers are not starting up fully after flashing with Gargoyle.

Any help will be appreciated.

Abe