Gargoyle Forum

The issue is solved: the course of unavaible web-interface is the f...g ESET SMART SECURITY aka NOD32! Rather it was the HTTP-scanning module.
Thank you very much!

The problem must be your computer or web browser. There are plenty of people using Gargoyle on their TL-WR1043ND without any problems. Did you actually try a different computer or web browser? Did you try to see if you can access the webpage using "telnet 192.168.1.1 80" and GET from the ...

MIX , THANK YOU VERY MUCH for helping at recovery my router to revert-factory firmware!!! Now I have access to Internet through the router! But: at 1st I've flashed router to experimental 1.5.2 firmware and still have not web-interface (192.168.1.1 is pinged and ssh/scp-ed). Then I revert firmware ...

Is NAT working? Can you access the internet through the router? I can give you some instructions on how to try a firmware flash again from the command line if it is, otherwise you might need to use scp to get the firmware onto the router. Let us know. By default, no: NAT don't working. It should be...

Try this: Power up your router. When the 'SYS' light starts to blink, press and hold the QSS button in the front-right until the blinking gets faster. You should now be able to telnet into your router at 192.168.1.1 Once you telnet in, issue the command "firstboot" to reset to defaults Sw...

I have installed at TP-LINK TL-WR1043ND wifi-router from original wr1043nv1_en_3_12_2_up(100820).bin firmware to gargoyle_1.4.5-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin . I've set IP of LAN interface 192.168.1.2 /255.255.255.0 mask (no Gateway set) and trying to connect to it by web-browser by add...