Gargoyle Forum

Hi rockyd I have the identical router. Some years ago my RSP (ABB) had a special deal on 1000/??, can not remember the upload speed. Anyway I upgraded to this for the duration of the deal time. I remember getting the 1000 download, or very close to it. I can not remember any settings, though probabl...

Thank you ektus and Lantis for your replys. Using some of the info ektus supplied I found all the static addresses in my main router in the file '/etc/config/dhcp'. I copied the static addresses from this file to the backup router, rebooted backup router and now all the static addresses are showing ...

Hello My main router is a WRT1900ACS running version 1.13.0. My backup router is also a WRT1900ACS but was running version 1.12.0. I have upgraded my backup router to 1.13.0 and would like to transfer a large amount of static IPs from the main router to the backup router. In version 1.12.0 I could d...

Hi. I have made a backup of my settings using 'Backup Current Configuration'. After this I had to reload the firmware in the router a few times. Now the router is running OK I am not sure if the backup file is based on the same version of firmware I have loaded. I have looked at the contents of the ...

Hi I have a similar router a Linksys WRT1900ACS which displayed a CPU temperature of just over 80°C when I got it. A bit of research showed this was 'normal', though I did not like it. I found that a normal small 12volt 3" case fan would power up from the USB ports on the router and run at a sl...

Hi. One of the laptops on my network is showing with a Hostname which is not the PC name or any name I can relate to the laptop. This laptop is not assigned a Static IP in Gargoyle so no Hostname is being forced in the router. Where does Gargoyle get the Hostname from for devices not assigned Static...

Hi As I have a lot of time on my hands at present due to Corona Virus, I thought I would ask a question which has been on my mind for some time. Following is a copy of my Gargoyle Status page. I notice the CPU load nearly always sits at "0". It does go up slightly if I change settings or s...

Hi all I am upgrading my router from a Netgear WNDR3700v4 running 1.10.X to a Lynksys WRT1900ACSv2. I am going to load Gargoyle 1.12.0 on the WRT1900ACSv2 and as I have a lot of mapped IP addresses I would like to avoid manually re-entering them. Can I do a clean install on the WRT1900ACSv2 and then...

Hi Lantis I am still having a problem with this one. Sorry for the long post, I tried to get as much info in as possible. I installed 1.12.0, all good. On checking the plug-ins, STA Manager was already installed. The plug-in tick box was grey and ticked, the button was labelled Uninstall and also gr...

Thanks Lantis

I will be installing on WNDR3700v2. Can I WinSCP in and check something to tell if STA Manager is automatically installed? Would be useful to know if i have to manually install for when I do future upgrades.

Thanks