Gargoyle Forum

Polipo has an option to enable/disable disk cache, so I turn it off and only use RAM cache (since I have much RAM available, I allocate 14MB for polipo) Polipo is working properly for me, but I still have some problems: Every computer needs to connect to the internet via the polipo proxy For example...

You probably have to read up on the manual and do some manual config editing via command line. You will also need to mount and configure a USB drive on the USB port, and setup a /cache directory there, and then point the config for polipo to use that directory. You wouldn't have space on the flash ...

I'm trying to run polipo on my TP-Link TL-WR1043ND, Gargoyle 1.4.4 I've installed polipo (using opkg), but I don't know how to config or test whether it is working or not. Please give me some hints. EDIT: I get an 403 when trying to access the polipo web interface. (yes, the router address is 192.16...

Delete the following 2 lines at the bottom: config include option path /usr/lib/gargoyle_firewall_util/gargoyle_additions.firewall This also will screw up the Bandwidth monitor graphing! Bandwidth Usage / B/W Distribution will not work when you delete the 2 above lines from the firewall config file...

ispyisail wrote:From my understanding you want to "open up" not "close down" the firewall?

I guess so.
My intention is to increase the maximum throughput of the router (with wired connection). Since I'm already behind my university firewall, I do not concern much about security issue.

I'm using v1.4.4 on TL-WR1043ND v1.7 How can I disable the firewall? I've tried http://www.gargoyle-router.com/phpbb/viewtopic.php?f=6&t=1243 /etc/init.d/firewall stop /etc/init.d/firewall disable but when the firewall is disabled, I cannot access the internet (I can still access the router web ...

ispyisail wrote:Revision d9a4129b

bump openwrt version farther, include newer ath9k fixes

ar71xx
http://goo.gl/wpvuq

I've just upgraded to 1.5.X (Built 20111129-1531 git@d9a4129)
No 'Service' menu on the left hand panel

EDIT: I reset all settings to default and install it again. Everything is ok now.

I think the idea is to prove whether your bandwidth increases past 4-5 MB/s using any of these different channels. is it going to make a big difference? probably these networks will change to other channels as well Can I disable the firewall to increase throughput? Actually, I tried /etc/init.d/fir...

What's your router's hardware version? Is it 1.8?
http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd

Channel 4
change to channel 1, wifi down, wifi up
Channel 1
Channel 2
Channel 3

Channel 5
Channel 6
Channel 7