Gargoyle Forum

Hi,

In the Status>Overview> Port Status table: if the connection is Gigabit, it reports as 100Mpbs, it should be 1000Mbps.

I am having a problem with Dynamic DNS since 1.3.16, take a look at my post: http://www.gargoyle-router.com/phpbb/viewtopic.php?f=6&t=1822 But I can configure it and it works for about 9 days. After that I have to reboot the router. Try to reset all your settings and reboot your router. After th...

After about 9 or 10 days the router stops updating throught DynDNS and even the Force Updade option does not work. The only solution is a reboot A possible work around would be to have your router do a ' Scheduled Reboot ' every day. I have mine set up to reboot every day at 12:01 AM. Thanks for re...

Hi again, Just to report that the problem with updating with DynDNS still happening in 1.5.0 the same way it was happening on previous versions on the TL-WR1043ND. After about 9 or 10 days the router stops updating throught DynDNS and even the Force Updade option does not work. The only solution is ...

Hi again, Just to report that the problem with updating with DynDNS still happening in 1.5.0 the same way it was happening on previous versions on the TL-WR1043ND. After about 9 or 10 days the router stops updating throught DynDNS and even the Force Updade option does not work. The only solution is ...

Hello Eric, Thank you very much for the update!! As I went back to the official firmware of my TL-WR1043ND, due to the dyndns not updating after a few days when using it with the Gargoyle 1.3.16 and 1.4.2. I am willing to install gargoyle again. Do you know if the problem was fixed on these versions...

Bump

Hello and thanks for this wonderful work. I have a TL-WR1043ND and I am using the latest 1.4.2 firmware. First I'd like to suggest a feature that is a manual entry in GUI for DSL modem access when in bridge. I know there is a automatic recognition of the modem IP address in bridge when the modem has...

Hello and thanks for this wonderful work. I have a TL-WR1043ND and I am using the latest 1.4.2 firmware. First I'd like to suggest a feature that is a manual entry in GUI for DSL modem access when in bridge. I know there is a automatic recognition of the modem IP address in bridge when the modem has...