Gargoyle Forum

I would put the gargoyle router in AP mode By AP mode do you mean Wireless Access Point mode? I am wanting the Gargoyle Router to connect via Ethernet to the ADSL so as to cut down on latency and wireless congestion. And also, as far as I know, you can only monitor hosts usage of the (ADSL) Interne...

Very legendary of you :) It's a... Vodafone Home Gateway ADSL Router (Model HUAWEI TECHNOLOGIES HG556a HW.C Which I guess is a Huawei HG556a HW.C branded by Vodafone New Zealand Upon further inspection: Product Name - EchoLife HG556a Software Version - V100R001C12B029 If I'm not mistaken, I think I ...

Awesome! Some good direction... This honestly makes sense, however-
I just went thru my modem settings and couldn't find anything in there with regards to bridge mode. Is it more likely that it can't do it or I'm not looking hard enough?

After chucking a notebook into the WAN port of the Gargoyle Router, I failed to: * ping 192.168.1.1 from the notebook when it was set to DHCP; * ping 192.168.1.1 from the notebook when it was statically assigned a legitimate IP address; * ping 192.168.1.1 from the notebook when it was set to DHCP an...

Adding to my confusion: Question - Can the WAN Port on my TP-LINK TL-WR1043ND be used without the Internet / WAN -> Connect Via: section being utilised? I read somewhere (can't remember) that the Bandwidth Usage will only monitor trafficked data through the WAN port. PS - Does anyone use Gargoyle? I...

Okay, so I'm slowly learning bits and pieces from trial and observation. Here's what I've learned, or think I have learned: * The B/W Distribution panel was not being populated (at all) for some reason. It turns out that it will populate correctly with information when using Firefox - yet it will no...

What you're saying is true - both the ADSL Router and Gargoyle Router are on the same 192.168.1.x network - I didn't think this would be a problem unless you had two DHCP servers contesting with each other. However, I'll give it a shot - putting the ADSL Router on a 192.168.2.x network and the Gargo...

Hi there guys, I need some help in configuring a Gargoyle Router to monitor the internet usage of ten devices shared by six people. I have spent a few hours playing around and reading up on walkthroughs ( eg http://bikemike.webnode.com/products/setting-up-a-gargoyle-router/ ) with little success. Pl...