Gargoyle Forum

The way you changed the password was with the passwd command? Hit enter while it shows the "keepalive lines" every second Like ar71xx_wdt_keepalive: 0xffb43480 ADR=b806000c " It than prints" root@gargoyle:/# type " passwd " You type the new passw repeat the new passwor...

The failsafe reset : I could not get it to work. I tried many times(at one stage I was ready to just dump the Bullet), and followed the instructions to the letter, yet i failed each time. Maybe it does not work with Ubiquiti, OR the previous owner screwed around with it OR it was my fault. Than you ...

The problem was that i purchased a "new' bullet m2 online. But it turned out that it was "slightly" used and someone removed the original AirOs and replaced it with the Gargoyle version.The gargoyle version was password locked. I emailed the seller, but "he" is out of the of...

I managed to change the PW.
Now I have full access.
I learned a lot over the last couple of days.

Many Many thanks to ispyisail & Lantis & top_s for your time, courtesy, patience and passed-on experience.
A happy and prosperous New Year wishes to you all from new zealand.

The "keepalive" lines come in too fast, I don't get the time to even type 6 characters. How do i slow this down?

Back again... I have Putty running on (Com12 115200 bps) the Bullet M2 via a FTDI232 adapter (connected in serial) On hitting ENTER it shows : root@gargoyle:/# For the rest it writes continuous lines like: ar71xx_wdt_keepalive: 0xffb43480 ADR=b806000c What do i put as a command to flash the new firm...

I read through it. Very comprehensive: It would have been much simpler to just show a couple of wiring diagrams. I have a couple of 4 pin & 6 pin ttl usb adapters in stock. No problems there. But what I need to know is, if the 4 pins on the pcb are ttl or not. I prefer not to damage either unit ...

RS232 cable?? How would you make the connection with RJ45 .
Or are you talking about something else

I tuned of the firewall--> it still does not connect. Ping is ok. re Wireshark: In the past I have had some really bad experiences with it including with Wincap -->So I don't install that anymore irrespective of where the download comes from. Vistumbler v10.6.4 lists 27 AP's with signal strengths of...

Yes. you are right. Spelling mistake.. Read MB instead of GB.
Either way, It won't connect. You got any ideas why??