Gargoyle Forum

Does it have to be the same subnet? If so, that is where I made my mistake earlier....

How do I set static IP? or choose DHCP?

Yes, but I can't access GUI so can't get SS....

I only changed those things that you mentioned. However, over to the right on the config panel was 192.168.1.1,255.255.255.0,192.168.1.1... tried that but no success either..

Since I did a full reset, is there a default?

What do I need to do to access my gargyle now that I have it operating as you suggested?

OK, yes... I am viewing the upsteam router's DHCP client list and there is no IP listed, however, the gargoyle AP is working, but I can't access the gargoyle??

OK, but how do I access my gargoyle now?

BTW - I have 14 wired devices which are served through my wired router. Then I have 17 wireless devices that my gargoyle wireless router originally choked on, but worked fine when I set it up in bridge mode (But was unable to access it again). I would like all of my devices to be served 192.168.0.xx...

I want my gargoyle wireless router to serve as a passthrough for connecting all of my wifi devices to my wired router and use the features on my wired router for ALL IPs in my house. So basically my gargoyle would serve as the wireless part of my wired router (if that makes sense).

OK, I guess my real question is... If I have setup my gargoyle for "bridge mode" and setup my wan port as a "bridge to LAN"... AND if my wired router that my gargoyle is bridged to hands out 192.168.0.xxx (gateway 192.168.0.1), what should I set my "Bridge IP" and "...