Gargoyle Forum

Should not be. It works fine with stock rom and dd-wrt.

The first link in your post refers to a very old rom. It was an issue at that time but it was fixed.
The second link in your post refers to WRT32X.

No it was a clean install. Did all the settings again.

Hi,

After flashing ver 1.11.0 on WRT3200ACM, the 2.4 Ghz radio does not come up.
Anyone else facing the same issue? I have guest network enable on 2.4 Ghz too.

Rog66 wrote:did you go back to factory firmware before flashing gargoyle? I find trying to flash direct from DD-wrt to gargoyle or lede does something similar to what you describe on my WRT1900ACS

Flashed from factory fw. I always keep one partition on factory fw.

Would be best I flash again. Is there a command in Gargoyle I can use to change the boot partition and boot up in factory fw? Something similar to ubootenv or Advanced Reboot in LEDE?

Thank you.

Hi, Have been using dd-wrt on my 3200acm for a few months now. Today I installed gargoyle_1.10.x-mvebu-armada-385-linksys-rango-squashfs-factory.img dated 2018-01-09 from lantisproject . com. Everything works fine and wireless hosts are connected to both 2.4 Ghz and 5 Ghz. But, I encountered 2 issue...