Gargoyle Forum

Ok probably you're right is there at least a way to access PC1 from PC2?

Not just a Port forwarding, I need to access PC1 by its IP with all ports.

- measure and manage Bandwidth Usage (quotas) in the 192.168.1.0 subnet

- minimizing the broadcast area (not yet sure if this works)

- using TOR for the 192.168.1.0 subnet clients and NOT for the 192.168.2.0 clients

I have the following configuration on my network http://img.pixady.com/2017/04/959036_network.png with default settings, I could access from PC1 to PC2. But now I want to access from PC2 to PC1 ( I want to access all PCs in this subnet and the other way round. ) So I've started with the following co...

thanks for your feedback mrpink57!

Ok, thanks for pointing that out. Last question back to TL-WR1043ND (which has 16MB and 750MHz CPU which should be equal or even better speed compared to Gargoyle Router and most bang for a buck) Is there a way to install Gargoyle on V4? https://wiki.openwrt.org/toh/tp-link/tl-wr1043nd I mean a gene...

The Gargoyle-Router is definelty not low budget.

I don't care about speed it's just for a few customers of my restaurant.

C7 v2 - there is another thread where C7 v3 is mentioned. So if I buy this one, I probably get the wrong version aswell.

TP-Link Archer C7 AC1750 is pretty high budget.

and

WARNING 1: Current firmware (1.9.0 and earlier) has been reported to brick recent models of Archer C7 v2 (Early 2016 and later)

https://www.gargoyle-router.com/download.php

I'm searching for a good and low budget router to run this image with TOR for my restaurant. After searching in this forum I have no clue which one to buy because the produncts are no longer available or in a different version available which is not (yet) supported. E.g. often mentioned (enough cpu ...