Gargoyle Forum

Hi, Does anyone know how to maintain the 2 values in the subject line? I'm reading that in order for ATAs to remain registered and working properly with a VoIP SIP provider like Freephoneline, in particular after power failures, the following conditions must be met: UDP Unreplied Timeout (in your ro...

Are you sure the ip address in bridged mode is 192.168.0.1? For example virgin cable routers use 192.168.0.1 in router mode as their default ip address but can be accessed at 192.168.100.1 in router or modem (bridged mode). This is an excellent question Rog66, how can I understand my bridged modem ...

I have a cable modem, isn't PPPoE used for a DSL connection?

Hello, I have setup Gargoyle in default Gateway mode. WAN is set to DHCP (Wired). Local network is on 192.168.1.x. Everything works fine, but I can't access the modem (in bridged mode, 192.168.0.1) via router. I followed a few threads "Accessing Bridged Modem", "Accessing Bridged VDSL...

Thanks for feedback Lantis. Not sure what the issue was, but here is what I did to solve the issue: I did reset back to factory settings both the cable modem and router to ensure that I start from a clean slate. Once the cable modem was set to bridge mode I did not connect the laptop anymore to test...

Hi, I installed latest Gargoyle firmware (gargoyle_1.9.2-ar71xx-generic-archer-c7-v2-squashfs-factory.bin) on Archer C7 v2 and would like to use it in bridge mode with my CGN2 cable modem/router. C7 works fine as an AP on the same network, but would like to move DHCP responsibility to C7 and get acc...