Gargoyle Forum

Ahh cool just looked at the changes. Will try them out once i get a chance. Unfortunately my primary router is a R7800 and not supported by most open source (yet, still early) or i would have Gargoyle on it.

Is it possible to configure the DHCP address on the wireless router connection to router 1?

If not will put in a reservation so i know where it is.

Just curious if the R7800 Netgear router will be supported. I noticed openwrt has support per a post https://www.myopenrouter.com/download/r ... t-firmware

Still new at this so was not sure as i did not see it on the hardware list.

Again thanks for the hard work. I really like the firmware. Tried DD-WRT and did not like the interface. OpenWRT was just too confusing.

Great. Thanks for all the help. Here is the output: root@Gargoyle:~# uci show wireless wireless.radio0=wifi-device wireless.radio0.type='mac80211' wireless.radio0.hwmode='11a' wireless.radio0.path='pci0000:01/0000:01:00.0' wireless.radio0.htmode='VHT80' wireless.radio0.channel='153' wireless.radio1=...

Well that explains ALOT!!! 1. Cleared and not happening. Thanks! 2. Got it setup on 192.168.2.1 3. The issue is still happening were it shows the wrong settings for the network after being setup. This is what i configured: http://purpledragonwear.com/temp/capture3.png This is what displays after reb...

I did not realize the board would not take attachments. Here are both screen grabs.

Sure here is a screen grab of the 2nd router configuration. The strange part is i can access the web gui for about 1-2 minutes after a reboot then it stops responding to access of all type. It still works as a bridge for the clients. Also i just noticed that the configuration shows different then wh...

So the web interface seems to respond after a while but i get this screen and not the log in. Same happens for both firmware after configuring. Does not happen until after configuration is set.

Hi all, New to open source firmware but been playing around with them alot recently. I am trying to setup an archer c7 v2 as a client to my wireless network hosted by a Netgear r7800 (stock firmware) I have the client bridge setup and clients are getting DHCP from the main router and all traffic see...