ubiquiti_routerstation_pro

This is an old revision of the document!

Ubiquiti Routerstation Pro

<alertbox> WARNING: This document may contain errors which may result in damage to your router. USE AT YOUR OWN RISK. </alertbox> inlinetoc_2_4

Introducing RouterStation Pro

In response to the outstanding demand for our initial RouterStation OEM platform, Ubiquiti Networks announces the RouterStation Pro

Features

Item802.3af 48V compatible
ItemGigabit Ethernet Switch (4 ports)
Item128MB RAM
Item16MB Flash
ItemUSB 2.0 Support
ItemSDIO Support
Item680MHz CPU (Option to overclock to 800)
ItemRobust ESD/Surge Protection for Industrial Applications
ItemSupport for 3 Ubiquiti SR,XR,or SR71 radios
ItemBuilt in dB9 connector
ItemEasy Access to full GPIO signals

Installing Firmware

Ubiquiti firmware recovery method

Requirements

Ubnt Router with power supply
Windows PC with NIC card
Ethernet cable for connection between PC and Ubiquiti router
Network settings of PC: 192.168.1.1/255.255.255.0
Install TFTP client on PC
Gargoyle Firmware

gargoyle_1.5.8-ar71xx-generic-ubnt-rspro-squashfs-factory.bin

Install Firmware

Power off the router
Press the router reset switch then apply power
Release the reset button after a few seconds
LED's should be flashing to indicate recovery mode
with PC set a fixed IP address 192.168.1.1/255.255.255.0
Assuming POE, connect Ethernet cable between “router power supply” and “PC”
(optional) Check router response by ping from command line

<shell> ping 192.168.1.20 </shell>

ubiquiti_routerstation_pro.1354690416.txt.gz · Last modified: 2012/12/05 06:53 (external edit)