Differences

This shows you the differences between two versions of the page.

--- ubiquiti_routerstation_pro [2012/12/05 06:02]
ispyisail
+++ ubiquiti_routerstation_pro [2012/12/05 07:07] (current)
ispyisail [Ubiquiti firmware recovery method]
@@ Line 31: / Line 31: @@
 === Requirements ===
+  * Ubnt Router with power supply
+  * Windows PC with NIC card
   * Ethernet cable for connection between PC and Ubiquiti router
   * Network settings of PC: 192.168.1.1/255.255.255.0
   * Install [[http://tftpd32.jounin.net/|TFTP ]] client on PC
-  * Firmware file
+  * Gargoyle [[http://www.gargoyle-router.com/download.php|Firmware]]
+gargoyle_1.5.8-ar71xx-generic-ubnt-rspro-squashfs-factory.bin
+=== Install Firmware ===
+  * Power off the router
+  * Press the router reset switch then apply power
+  * Release the reset button after a few seconds
+  * LED's should be flashing to indicate recovery mode
+  * with PC set a fixed IP address 192.168.1.1/255.255.255.0
+  * Assuming POE, connect Ethernet cable between "router power supply" and "PC"
+  * (optional) Check router response by pinging from PC command line
+<shell>
+ping 192.168.1.20
+</shell>
+  * Run TFTP server
+    * Select >> Tftp Client
+    * Select >> Server interface:192.168.1.1 (Note: you need a wired connection to be able to do this)
+    * Enter Host Address:192.168.1.20
+    * Select file to flash gargoyle_1.5.8-ar71xx-generic-ubnt-rspro-squashfs-factory.bin
+    * Click >> Put
+{{ :tftp.png?500 |}}
+Wait 10 minutes and router should be flashed with new firmware.
+Reset PC NIC back to DHCP then connect PC NIC to LAN port of your router.
+You should be able to connect to the gargoyle interface by entering into your browser 192.168.1.1

Gargoyle Wiki

User Tools

Site Tools

Differences

Page Tools