swap_file
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
swap_file [2012/02/09 07:16] ispyisail |
swap_file [2012/02/11 18:08] (current) ispyisail |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| There are some applications and network situations that may require the need for more RAM, like DLNA file indexing, Tor or disk checks. There are a couple of options of upgrading RAM, via soldering or using a SWAP partition on a USB thumb drive. This how-to describes installing SWAP on a USB thumb drive. This method is a bit slower but also more convenient. Your router will need a USB port like the TP-Link TL-WR1043ND v1-1.8 | There are some applications and network situations that may require the need for more RAM, like DLNA file indexing, Tor or disk checks. There are a couple of options of upgrading RAM, via soldering or using a SWAP partition on a USB thumb drive. This how-to describes installing SWAP on a USB thumb drive. This method is a bit slower but also more convenient. Your router will need a USB port like the TP-Link TL-WR1043ND v1-1.8 | ||
| + | |||
| + | This feature only works with gargoyle firmware 1.5.2 and above | ||
| The SWAP partition should automatically mount after plugging the right media into router USB port. You may need to reboot your router or run | The SWAP partition should automatically mount after plugging the right media into router USB port. You may need to reboot your router or run | ||
swap_file.txt ยท Last modified: 2012/02/11 18:08 by ispyisail
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
