scenario-modem
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
scenario-modem [2015/05/04 01:29] nworbnhoj [Configure Gargoyle] formatting |
scenario-modem [2015/05/04 08:25] nworbnhoj [Reconfigure existing Modem/Router] formatting |
||
|---|---|---|---|
| Line 21: | Line 21: | ||
| To Bridge or not to Bridge, that is the question! | To Bridge or not to Bridge, that is the question! | ||
| - | If you are configuring an __ADSL__ modem then it is preferable (if possible) to put the modem into **bridge** mode; which in effect, will connect Gargoyle directly to your ISP. | + | If you are configuring an __ADSL__ modem then it is preferable (if possible) to put the modem in**to bridge** mode; which in effect, will connect Gargoyle directly to your ISP. |
| - | Otherwise, set the Modem LAN IP Address to **192.168.0.1** to form one node on a very simple network segment just between the Modem and the Gargoyle router (see below). Another network segment will connect all of your devices with IP addresses like 192.168.1.XXX | + | Otherwise, |
scenario-modem.txt ยท Last modified: 2015/05/04 14:05 by nworbnhoj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
