This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
failsafe_mode_recovery [2017/07/30 07:58] ispyisail [Failsafe recovery via ssh] |
failsafe_mode_recovery [2018/02/12 11:44] ispyisail [Failsafe recovery via telnet] |
||
---|---|---|---|
Line 22: | Line 22: | ||
===== Failsafe recovery via telnet ===== | ===== Failsafe recovery via telnet ===== | ||
+ | |||
+ | |||
This procedure assumes that: | This procedure assumes that: | ||
Line 31: | Line 33: | ||
NOTE: Unplug all external drives from the router or they will be erased by the firstboot process. | NOTE: Unplug all external drives from the router or they will be erased by the firstboot process. | ||
+ | |||
+ | Firmware recovery changed with 1.10.x | ||
+ | - Use SSH not Telnet for recovery | ||
+ | - Use “firstboot -y” instead of “firstboot” | ||
+ | |||
+ | |||
+ | Procedure for 1.10.x and above | ||
+ | |||
+ | To recover: | ||
+ | - Install [[http:// | ||
+ | - Configure your computer with static IP 192.168.1.2 | ||
+ | - Connect your computer to a LAN port on the router. | ||
+ | - Start Wireshark and monitor the LAN connection. | ||
+ | - Powerup your router, when wireshark shows the first packet from 192.168.1.1 immediately press and hold the reset button on the back of the router for three seconds. | ||
+ | - Router power LED should be flashing quickly. (Failsafe mode) | ||
+ | - SSH via putty to " | ||
+ | - at the Gargoyle prompt type '' | ||
+ | - __wait__ until the command prompt returns | ||
+ | - power cycle the router. | ||
+ | The router which should now come up in its default Gargoyle configuration and you will be able to [[getting_started|get started]] again. | ||
+ | |||
+ | |||
+ | Procedure for any firmware below 1.10.x | ||
To recover: | To recover: |