Differences

This shows you the differences between two versions of the page.

--- buffalo_wzr-hp-g300nh [2012/02/11 09:35]
ispyisail
+++ buffalo_wzr-hp-g300nh [2015/09/01 21:38] (current)
nworbnhoj [Buffalo WZR-HP-G300NH]
@@ Line 1: / Line 1: @@
-====== Warning ======
+======= Buffalo WZR-HP-G300NH =======
 <alertbox>
@@ Line 10: / Line 10: @@
 </alertbox>
-====== Introduction ======
+===== Introduction =====
 Step-by-step instructions for the non technical person who wants to install Gargoyle on a Buffalo WZR-HP-G300NH.
-====== Requirements ======
+===== Requirements =====
 Factory stock Buffalo WZR-HP-G300NH router and upgrading it to Gargoyle
-====== Upgrade to DD-WRT ======
+===== Upgrade to DD-WRT =====
 Use the Buffalo setup to switch from the "user friendly" firmware to the Buffalo factory default "Professional" firmware (DD-WRT)
-====== Set Password ======
+===== Set Password =====
 Logged into DD-WRT at 192.168.11.1 and set a new password and wrote it down.
-====== Telnet ======
+===== Telnet =====
-===== Install Telnet =====
+==== Install Telnet ====
 Installed Telnet on Windows 7 from control panel.
-===== Login with Telent =====
+==== Login with Telent ====
 Opened Telnet and entered:
@@ Line 44: / Line 44: @@
 After successful login, copied and pasted these commands to telnet
-===== Upgrade to Gargoyle =====
+==== Upgrade to Gargoyle ====
@@ Line 63: / Line 63: @@
 Finally, the screen said "lost connection"
-====== Gargoyle ======
+===== Gargoyle =====
 Gargoyle changed the default IP address to 192.168.1.1

Gargoyle Wiki