This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
buffalo_wzr-hp-g300nh [2011/12/09 03:46] ispyisail |
buffalo_wzr-hp-g300nh [2015/09/01 21:38] (current) nworbnhoj [Buffalo WZR-HP-G300NH] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ======= |
+ | |||
+ | < | ||
+ | WARNING: This document may contain errors which may result in damage to your router. USE AT YOUR OWN RISK. | ||
+ | </ | ||
+ | |||
+ | < | ||
+ | NOTE: More recent versions of the WZR-HP-G300NH have had a hardware change without bumping the revision number or changing the hardware label. | ||
+ | The newer hardware appears to have the rtl8366rb Ethernet switch while older hardware had the rtl8366s switch. As a result, this newer hardware is **NOT** supported by OpenWrt ' | ||
+ | </ | ||
+ | |||
+ | ===== Introduction | ||
Step-by-step instructions for the non technical person who wants to install Gargoyle on a Buffalo WZR-HP-G300NH. | Step-by-step instructions for the non technical person who wants to install Gargoyle on a Buffalo WZR-HP-G300NH. | ||
- | ====== Requirements | + | ===== Requirements ===== |
Factory stock Buffalo WZR-HP-G300NH router and upgrading it to Gargoyle | Factory stock Buffalo WZR-HP-G300NH router and upgrading it to Gargoyle | ||
- | ====== Upgrade to DD-WRT | + | ===== Upgrade to DD-WRT ===== |
Use the Buffalo setup to switch from the "user friendly" | Use the Buffalo setup to switch from the "user friendly" | ||
- | ====== Set Password | + | ===== Set Password ===== |
Logged into DD-WRT at 192.168.11.1 and set a new password and wrote it down. | Logged into DD-WRT at 192.168.11.1 and set a new password and wrote it down. | ||
- | ====== Telnet | + | ===== Telnet ===== |
- | ===== Install Telnet | + | ==== Install Telnet ==== |
Installed Telnet on Windows 7 from control panel. | Installed Telnet on Windows 7 from control panel. | ||
- | ===== Login with Telent | + | ==== Login with Telent ==== |
Opened Telnet and entered: | Opened Telnet and entered: | ||
Line 33: | Line 44: | ||
After successful login, copied and pasted these commands to telnet | After successful login, copied and pasted these commands to telnet | ||
- | ===== Upgrade to Gargoyle | + | ==== Upgrade to Gargoyle ==== |
Line 41: | Line 52: | ||
</ | </ | ||
- | after the wget command, the screen showed a download progress bar and then completion | + | After the wget command, the screen showed a download progress bar and then completion |
< | < | ||
Line 48: | Line 59: | ||
</ | </ | ||
- | after mtd command, screen showed several commands, then nothing for a long time. Be patient. | + | After mtd command, screen showed several commands, then nothing for a long time. Be patient. |
Finally, the screen said "lost connection" | Finally, the screen said "lost connection" | ||
- | ====== Gargoyle | + | ===== Gargoyle ===== |
Gargoyle changed the default IP address to 192.168.1.1 | Gargoyle changed the default IP address to 192.168.1.1 |