Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
bridge_repeater [2018/07/01 02:55]
ispyisail [Introduction]
bridge_repeater [2018/07/01 02:56]
ispyisail [Access option 1]
Line 7: Line 7:
 Wireless Bridge/​Repeater mode in Gargoyle uses relayd. This is also known as a Routed Client with relayd (Pseudobridge). The relayd package helps to implement a bridge-like behaviour with DHCP and Broadcast relaying comparable to the proprietary Broadcom WET mode. Wireless Bridge/​Repeater mode in Gargoyle uses relayd. This is also known as a Routed Client with relayd (Pseudobridge). The relayd package helps to implement a bridge-like behaviour with DHCP and Broadcast relaying comparable to the proprietary Broadcom WET mode.
  
-Use this mode with caution, see below for details.+**Use this mode with caution, see below for details.**
  
 {{:​relayd.png?​550|}} {{:​relayd.png?​550|}}
Line 23: Line 23:
 ==== Access option 1 ==== ==== Access option 1 ====
  
-If the configuration is setup correctly the new IP address for the "​relayd router"​ will be in the DHCP table of the AP router under the name "​unknown"​. ​+If the configuration is setup correctly the new IP address for the **"​relayd router"​** will be in the DHCP table of the **"AP router"​** ​under the name "​unknown"​. ​
  
 {{:​screenshots:​2018-07-01_14_30_43-gargoyle_router_management_utility.jpg?​500|}} {{:​screenshots:​2018-07-01_14_30_43-gargoyle_router_management_utility.jpg?​500|}}
bridge_repeater.txt ยท Last modified: 2018/07/01 02:56 by ispyisail
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki