Gargoyle Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.


====== Asus WL500G Premium (V1 & V2) ======

<alertbox>
WARNING: This document may contain errors which may result in damage to your router. USE AT YOUR OWN RISK.
</alertbox>
{{INLINETOC 2 4 }} 

==== Introduction ====

The Asus WL500G Premium is another router that uses a broadcom wireless chip and is very much like the LinksysWRT54G* routers. You will want to use the generic .trx image for this router. The best way to upload it is using the upgrade utility for Windows that ships with the router. Unfortunately, the upgrade utility on the web interface that ships with this router is incompatible with existing third-party firmware.
==== Install Firmware ====
=== Primary Install  Method ===
 

Before installing on this router you need to put it in 'diag' mode. To do this, follow the following steps:
  - Unplug the router's power cord. 
  - Confirm your PC is configured to request an address via DHCP.
  - Connect the router's LAN1 port directly to your PC.
  - Push the black RESTORE button using a pen or such, and keep the button pushed down.
  - Plug the power on while keeping the RESTORE button pushed for few seconds.
  - When you see a slowly blinking power light, you are in diag mode.

Once you are in diag mode you can use the windows utility to upgrade the firmware.
=== Secondary Install Method ===

Alternatively, you can connect to the router via tftp when it is in diag mode.  Follow [[http://oldwiki.openwrt.org/OpenWrtDocs(2f)Installing(2f)TFTP.html|these instructions]] to transfer and install the image via tftp.
==== 3rd party firmware ====

Like the broadcom-based Linksys routers, if you already have other 3rd party firmware such as Tomato or DD-WRT installed, you can upgrade directly from there using the generic broadcom .trx file.
Gargoyle Wiki

User Tools

Site Tools

Page Tools
