inlinetoc_2_4

Gargoyle supports PPPoE connections over ADSL links. ADSL links use phone lines as there physical connection to the internet. The phone line required special modem equipment on both ends and filters to allow the line to be simultaneously used as a phone connection. Gargoyle does not support PPPoA connections directly.

For those of you that have PPPoE connections and want to deploy a Gargoyle router you would be wise to pay attention to the configuration of your ADSL device. Most of these devices can be configured as routers themselves but since you are using Gargoyle it is best if you change the configuration the into a simple modem. The name of this mode varies by manufacturer. The term “bridged mode” seems the most common but something like “modem mode” or “simple ADSL modem” may also be used. Changes to these devices are typically made through a web page you can access using the modem's IP address.

There are several reasons to configure your modem in this fashion. First the performance of Gargoyle's QoS will be improved since it will account for PPPoE overhead leading to more accurate control. Second your ADSL Router becomes transparent and your Gargoyle router will obtain your WAN (wide area network) IP address directly. This is useful should you need to port forward or remotely gain access to your network from the internet.

Before you change the device into modem mode make sure that you enable DHCP on the device. In most of these devices DHCP can be active in modem mode although sometimes it is necessary to configure it before you change modes. If you do this step you will automatically be able to access your modem's web page from your LAN without further configuration.

• PPPoE connection (PPPoA is not suitable)
• Suitable xDSL modem (Netgear DG834)
• Gargole Router with SSH access

Medium linux skills are required as CLI (command line Interface) is needed.

First set up your xDSL modem

Change the router IP address to 192.168.10.1

Then follow these instructions

http://vpncasestudy.com/download/DG/DG834_Tips100.pdf

NOTE Once in 'Modem only' mode the DG834 will act as a simply modem, its IP address will have no relevance except for connecting to the router to change settings or reconfigure. Remember this IP address, as DHCP will no longer function and you will need it if you wish to connect to the DG834 in future.

The default AP mode is fine, setup from the GUI.

With SSH access find and edit

/etc/ppp/ip-up.d/modemaccess.sh

#This script allows access to the ADSL modem web interface when pppoe is used.
#For this to work configure your modem in brdige mode with DHCP enabled on the modem.
#This will cause the modem to dish an address to the router interface when requested below.
#
#Alternatively you can manually set the below variable ROUTER_IP with the IP address
#you want to use. Make sure the IP address is on the same network as the modem.
#ROUTER_IP=10.0.0.2

Edit and Change <shell> #ROUTER_IP=10.0.0.2 </shell> to <shell> ROUTER_IP=192.168.10.2 </shell>

Reboot your Gargoyle router and everything should work