Ubiquiti Routerstation Pro

<alertbox> WARNING: This document may contain errors which may result in damage to your router. USE AT YOUR OWN RISK. </alertbox> inlinetoc_2_4

In response to the outstanding demand for our initial RouterStation OEM platform, Ubiquiti Networks announces the RouterStation Pro

• Item802.3af 48V compatible
• ItemGigabit Ethernet Switch (4 ports)
• Item128MB RAM
• Item16MB Flash
• ItemUSB 2.0 Support
• ItemSDIO Support
• Item680MHz CPU (Option to overclock to 800)
• ItemRobust ESD/Surge Protection for Industrial Applications
• ItemSupport for 3 Ubiquiti SR,XR,or SR71 radios
• ItemBuilt in dB9 connector
• ItemEasy Access to full GPIO signals

• Ubnt Router with power supply
• Windows PC with NIC card
• Ethernet cable for connection between PC and Ubiquiti router
• Network settings of PC: 192.168.1.1/255.255.255.0
• Install TFTP client on PC
• Gargoyle Firmware

gargoyle_1.5.8-ar71xx-generic-ubnt-rspro-squashfs-factory.bin

• Power off the router
• Press the router reset switch then apply power
• Release the reset button after a few seconds
• LED's should be flashing to indicate recovery mode
• with PC set a fixed IP address 192.168.1.1/255.255.255.0
• Assuming POE, connect Ethernet cable between “router power supply” and “PC”
• (optional) Check router response by pinging from PC command line

<shell> ping 192.168.1.20 </shell>

• Run TFTP server
  • Select » Tftp Client
  • Select » Server interface:192.168.1.1 (Note: you need a wired connection to be able to do this)
  • Enter Host Address:192.168.1.20
  • Select file to flash gargoyle_1.5.8-ar71xx-generic-ubnt-rspro-squashfs-factory.bin
  • Click » Put

Wait 10 minutes and router should be flashed with new firmware.

Reset PC NIC back to DHCP then connect PC NIC to LAN port of your router.

You should be able to connect to the gargoyle interface by entering into your browser 192.168.1.1