======= Buffalo WZR-HP-G300NH =======
WARNING: This document may contain errors which may result in damage to your router. USE AT YOUR OWN RISK.
NOTE: More recent versions of the WZR-HP-G300NH have had a hardware change without bumping the revision number or changing the hardware label.
The newer hardware appears to have the rtl8366rb Ethernet switch while older hardware had the rtl8366s switch. As a result, this newer hardware is **NOT** supported by OpenWrt 'Backfire' 10.03.1-RC5 but it is supported in OpenWrt trunk since at least r28133
===== Introduction =====
Step-by-step instructions for the non technical person who wants to install Gargoyle on a Buffalo WZR-HP-G300NH.
===== Requirements =====
Factory stock Buffalo WZR-HP-G300NH router and upgrading it to Gargoyle
===== Upgrade to DD-WRT =====
Use the Buffalo setup to switch from the "user friendly" firmware to the Buffalo factory default "Professional" firmware (DD-WRT)
===== Set Password =====
Logged into DD-WRT at 192.168.11.1 and set a new password and wrote it down.
===== Telnet =====
==== Install Telnet ====
Installed Telnet on Windows 7 from control panel.
==== Login with Telent ====
Opened Telnet and entered:
o 192.168.11.1
prompted for user name and password
used "root" for user name (regardless of user name specified when installing DD-WRT)
Use the password set when configuring DD-WRT.
After successful login, copied and pasted these commands to telnet
==== Upgrade to Gargoyle ====
cd /tmp
wget http://www.gargoyle-router.com/downloads/images/ar71xx/gargoyle_1.4.4-ar71xx-wzr-hp-g300nh-squashfs-sysupgrade.bin
After the wget command, the screen showed a download progress bar and then completion
mtd -e linux -r write gargoyle_1.3.14-ar71xx-wzr-hp-g300nh-squashfs-sysupgrade.bin linux
After mtd command, screen showed several commands, then nothing for a long time. Be patient.
Finally, the screen said "lost connection"
===== Gargoyle =====
Gargoyle changed the default IP address to 192.168.1.1
Opened a browser and entered 192.168.1.1
Got the Gargoyle login screen. The default password is "password"
Changed the Gargoyle password. All ready to configure and use!