upgrade_config
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
upgrade_config [2012/02/11 08:53] ispyisail |
upgrade_config [2013/05/21 16:07] (current) eric |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== How-to Keep Router Configuration after an Upgrade ====== | ====== How-to Keep Router Configuration after an Upgrade ====== | ||
| - | {{INLINETOC 2 4 }} | ||
| - | ===== Question ===== | ||
| + | ===== Question ===== | ||
| + | | ||
| Is there any reason why it is not possible for Gargoyle to remember its configuration after an upgrade? | Is there any reason why it is not possible for Gargoyle to remember its configuration after an upgrade? | ||
| It is possible on almost all firmware (including openwrt). This would make the upgrade process so much more pleasant. | It is possible on almost all firmware (including openwrt). This would make the upgrade process so much more pleasant. | ||
| Line 8: | Line 8: | ||
| ===== Answer ===== | ===== Answer ===== | ||
| - | Yes | + | Yes. This is what the checkbox in Gargoyle 1.5.3+ does, however there will be incompatibilities when there are major changes between versions. |
| + | |||
| + | In versions of Gargoyle prior to 1.5.3, the solution below will allow this option even though it is not present in the GUI. | ||
| ===== Solution ===== | ===== Solution ===== | ||
upgrade_config.1328950391.txt.gz · Last modified: 2012/02/11 08:53 by ispyisail
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
