Differences

This shows you the differences between two versions of the page.

--- single_ethernet_setup [2010/08/21 09:14]
ispyisail
+++ single_ethernet_setup [2013/05/21 15:49] (current)
eric
@@ Line 1: / Line 1: @@
 ====== Configuring Routers With One Ethernet Port======
+===== Introduction =====
 Some wireless routers such as the MR3201A and the original La Fonera 2200 have only one ethernet port.  This guide is meant to help users configure a router like this.
-====== Initial Configuration ======
+===== Initial Configuration =====
 When you first install Gargoyle firmware, wireless connectivity is disabled for security reasons.  Therefore you will need to connect the router to your computer via an ethernet cable:
@@ Line 25: / Line 31: @@
   - [[single_ethernet_setup#Configuring Wireless Client Mode|Use the router as a wireless client]]
-====== Configuring A Wireless Access Point ======
+===== Configuring A Wireless Access Point =====
 Configuring the router as an access point allows multiple computers to wirelessly share a single wired connection:
@@ Line 98: / Line 104: @@
-====== Configuring Wireless Client Mode ======
+===== Configuring Wireless Client Mode =====
 A router in wireless client mode allows the connection of a wired computer  to an existing wireless network:

Gargoyle Wiki