Gargoyle Wiki

User Tools

Site Tools

Trace: • connected_hosts • scenario-modem • 1.6.x • remote_syslog • connection_list
bridge_repeater

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
bridge_repeater [2017/10/05 01:44]
ispyisail [Relayd Router connection] 		bridge_repeater [2018/07/01 02:56] (current)
ispyisail [Access option 1]
Line 6: Line 6:
  
 Wireless Bridge/Repeater mode in Gargoyle uses relayd. This is also known as a Routed Client with relayd (Pseudobridge). The relayd package helps to implement a bridge-like behaviour with DHCP and Broadcast relaying comparable to the proprietary Broadcom WET mode. Wireless Bridge/Repeater mode in Gargoyle uses relayd. This is also known as a Routed Client with relayd (Pseudobridge). The relayd package helps to implement a bridge-like behaviour with DHCP and Broadcast relaying comparable to the proprietary Broadcom WET mode.
 +
 +**Use this mode with caution, see below for details.**
  
 {{:relayd.png?550|}} {{:relayd.png?550|}}
Line 15: Line 17:
 {{:basic_wireless_bridge.png?550|}} {{:basic_wireless_bridge.png?550|}}
  
-===== Relayd Router connection =====+===== Relayd Router connection access ===== 
 + 
 +When the save button is pressed you will loose router connection. If the wrong configuration is entered it is possible that the only option to connect/recover the relayd router is a  "**failsafe reset**" 
 + 
 +==== Access option 1 ==== 
 + 
 +If the configuration is setup correctly the new IP address for the **"relayd router"** will be in the DHCP table of the **"AP router"** under the name "unknown".  
 + 
 +{{:screenshots:2018-07-01_14_30_43-gargoyle_router_management_utility.jpg?500|}} 
 + 
 +==== Access option 2 ==== 
 + 
 +If you can remember the "Bridge IP" you can manualy set the NIC IP to be in the same subnet and access via Bridge IP address 
 + 
 +{{:screenshots:bridge_ip.jpg?500|}} 
 + 
 +{{::nic_address.jpg?500|}} 
 + 
 + 
 +===== Caveat ===== 
 + 
 +Devices can only access to the internet if Enforce DHCP assignments is unticked.
  
-When the save button is pressed you will loose router connection. If the wrong configuration is entered it is possible that the only option to connect/recover the relayd router is a  "failsafe reset"+If the "relayed router" can not access "Wireless AP" all connections will be lost including access to the relayed router.
  
-If the configuration is correct the new IP address for the relayd router will be in the DHCP table of the AP router under the name "unknown" 
  
  
bridge_repeater.1507167885.txt.gz · Last modified: 2017/10/05 01:44 by ispyisail

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki