Differences

This shows you the differences between two versions of the page.

--- bridge_repeater [2017/10/05 00:25]
ispyisail created
+++ bridge_repeater [2018/07/01 02:56] (current)
ispyisail [Access option 1]
@@ Line 6: / Line 6: @@
 Wireless Bridge/Repeater mode in Gargoyle uses relayd. This is also known as a Routed Client with relayd (Pseudobridge). The relayd package helps to implement a bridge-like behaviour with DHCP and Broadcast relaying comparable to the proprietary Broadcom WET mode.
+**Use this mode with caution, see below for details.**
+{{:relayd.png?550|}}
+===== Configuration =====
+This example is for the Gargoyle relayd router. Connect to the SSID of the wireless AP router using known connection parameters.
+{{:basic_wireless_bridge.png?550|}}
+===== Relayd Router connection access =====
+When the save button is pressed you will loose router connection. If the wrong configuration is entered it is possible that the only option to connect/recover the relayd router is a  "**failsafe reset**"
+==== Access option 1 ====
+If the configuration is setup correctly the new IP address for the **"relayd router"** will be in the DHCP table of the **"AP router"** under the name "unknown".
+{{:screenshots:2018-07-01_14_30_43-gargoyle_router_management_utility.jpg?500|}}
+==== Access option 2 ====
+If you can remember the "Bridge IP" you can manualy set the NIC IP to be in the same subnet and access via Bridge IP address
+{{:screenshots:bridge_ip.jpg?500|}}
+{{::nic_address.jpg?500|}}
+===== Caveat =====
+Devices can only access to the internet if Enforce DHCP assignments is unticked.
+If the "relayed router" can not access "Wireless AP" all connections will be lost including access to the relayed router.

Gargoyle Wiki

User Tools

Site Tools

Differences

Page Tools