Page 1 of 1
Ubiquiti NanoStation loco M2
Posted: Sat Nov 26, 2016 11:59 am
by billsteiner
Help, I just flashed my loco M2 with gargoyle_1.8.1-ar71xx-generic-ubnt-nano-m-squashfs-factory and now I can't access it. I have tried 192.168.1.1 but no response. The power and lan lights are on along with the last light on the power scale. Would anyone have a suggestion.
Thanks
Re: Ubiquiti NanoStation loco M2
Posted: Sat Nov 26, 2016 5:29 pm
by Lantis
Try SSH into it, or activate failsafe
Re: Ubiquiti NanoStation loco M2
Posted: Sun Nov 27, 2016 12:43 am
by ispyisail
I wonder if its a 4 meg router?
Re: Ubiquiti NanoStation loco M2
Posted: Sun Nov 27, 2016 8:07 am
by billsteiner
Just received this info:
Code: Select all
Special Firmware Note: AirOS XM.v5.5.X images used U-Boot 1.1.4.2-s594 (Dec 5 2012 - 15:23:07). The OpenWRT image can be successfully flashed onto these versions of firmware. However, in July 2015 Ubiquiti released a new version of firmware XM.v5.6.X. With this firmware a new U-Boot version was released, U-Boot 1.1.4.2-s956 (Jun 10 2015 - 10:54:50). The newer U-Boot version changes the memory size and starting address for rootfs, cfg, and EEPROM. LOADING AN OPENWRT IMAGE ON A U-Boot 1.1.4.2-s956 WILL CAUSE THE DEVICE TO BE BRICKED!!!
Yep, I bricked it...can't ssh in and failsafe doesn't work.
PS. It's not a router, it's a Wi-Fi access point
Re: Ubiquiti NanoStation loco M2
Posted: Sun Nov 27, 2016 3:41 pm
by Lantis
Oops!
Live and learn I suppose.
You could try serial at this point. Not much to lose.