Page 1 of 2
Back to Stock Firmware
Posted: Fri Nov 12, 2010 10:09 am
by Nathansz
Unfortunately I have to return my TP-Link WR1043ND back to the store with the original firmware, its a long story. Just when I got it working well!
How would I go about getting back to stock firmware, obviously you cant just "upgrade" from the web ui. Would I upgrade to openwrt and then back to stock firmware? not sure if this would work because ive never used open wrt but I remember reading that somewhere.
Can anyone steer me in the right to direction?
Re: Back to Stock Firmware
Posted: Fri Nov 12, 2010 3:59 pm
by Cezary
Re: Back to Stock Firmware
Posted: Sat Nov 13, 2010 1:25 am
by Nathansz
thanks
Re: Back to Stock Firmware
Posted: Sun Nov 14, 2010 11:41 pm
by Bthree
All good, Ta
Re: Back to Stock Firmware
Posted: Thu Nov 18, 2010 5:27 pm
by nikil511
link does not work anymore
Are these the same as the one on the TP-LINK site ?
Or will these brick the router ?
http://www.tp-link.com/support/download ... L-WR1043ND
I found another source for stock firmware:
http://samiux.blogspot.com/2010/03/howt ... 043nd.html
Can I use this via the GUI as well ?
Thanks
Re: Back to Stock Firmware
Posted: Thu Nov 18, 2010 6:16 pm
by Bthree
That one will work and yes as Cezary says, use GUI
Re: Back to Stock Firmware
Posted: Fri Nov 19, 2010 7:11 am
by nikil511
Thanks! it did work...
For the record:
I wanted to do some USB HDD transfer tests with the stock firmware.
I get 6-4MB/sec on LAN , and only 600-800kb/sec on WAN ...
Re: Back to Stock Firmware
Posted: Fri Nov 19, 2010 10:20 am
by Nathansz
Is this suprising to you? I get similear wan speeds
Re: Back to Stock Firmware
Posted: Sun Nov 21, 2010 4:33 am
by bigg
Nice topic , I'm going to return to the factory firmware
Re: Back to Stock Firmware
Posted: Sun Nov 21, 2010 6:22 am
by vplessky
bigg wrote:Nice topic , I'm going to return to the factory firmware
Looking forward to see you back with Gargoyle installed