Page 1 of 1
TP-Link TL-WR841ND v10 ?
Posted: Mon Sep 05, 2016 9:40 am
by mentos265
So TL-WR841ND v3-9 are supported but v10 isnt?
Any information on that? Can I use the firmware from v9?
It is supported by openWrt tough.
https://wiki.openwrt.org/de/toh/tp-link/tl-wr841nd
Thx
Re: TP-Link TL-WR841ND v10 ?
Posted: Mon Sep 12, 2016 3:22 pm
by schnurlos
Have a look on the Download section:
gargoyle_1.9.1-ar71xx-generic-tl-wr841n-v10-squashfs-sysupgrade.bin
gargoyle_1.9.1-ar71xx-generic-tl-wr841n-v10-squashfs-factory.bin
So with 1.9.1 the V10 of the TP-Link TL-WR841ND is supported
Re: TP-Link TL-WR841ND v10 ?
Posted: Tue Sep 13, 2016 2:04 pm
by mentos265
schnurlos wrote:Have a look on the Download section:
gargoyle_1.9.1-ar71xx-generic-tl-wr841n-v10-squashfs-sysupgrade.bin
gargoyle_1.9.1-ar71xx-generic-tl-wr841n-v10-squashfs-factory.bin
So with 1.9.1 the V10 of the TP-Link TL-WR841ND is supported
But its not wr81n
D tough. Does it make any difference? I dont want to brick my router
Re: TP-Link TL-WR841ND v10 ?
Posted: Tue Sep 13, 2016 4:54 pm
by Lantis
They are the same internally.
Re: TP-Link TL-WR841ND v10 ?
Posted: Wed Sep 14, 2016 2:03 pm
by mentos265
Thx I now have gargoyle on my router.
The reason I switched to Gargoyle is the following:
I would like to limit the bandwidth for all clients that connect to this router.
Now my TL-WR841ND is set as a AP and connects to the router of my provider
Setting quotas seems to have no effect. The download speed seems to drop form 11 mbps to 5-8 mbps even tough I limited the bandwidth to 200 kbytes/s. The upload speed seems not to change at all.
I have set the quota for the entire local network, and for all induvidual hosts and host without explicit quota. that does not change anything
I have Dhcp disabled if that matters
Re: TP-Link TL-WR841ND v10 ?
Posted: Wed Sep 14, 2016 4:45 pm
by Lantis
Can you please share your quotas settings with another screenshot
Please capture the edit dialog of the quota to get the full details
Re: TP-Link TL-WR841ND v10 ?
Posted: Thu Sep 15, 2016 2:37 pm
by mentos265
Lantis wrote:Can you please share your quotas settings with another screenshot
Please capture the edit dialog of the quota to get the full details
Here is it:
Re: TP-Link TL-WR841ND v10 ?
Posted: Thu Sep 15, 2016 11:38 pm
by Lantis
My only suggestion is to try throttling the bandwidth using QOS instead.
Set up a QOS class for slow traffic with the limit you want imposed.
Then on the quota, change the throttle bandwidth to drop the traffic into the slow QOS class.
Re: TP-Link TL-WR841ND v10 ?
Posted: Fri Sep 16, 2016 8:25 am
by danymarc
@lantis he posted this
Now my TL-WR841ND is set as a AP and connects to the router of my provider
Doesn't have to be Router mode not AP
Re: TP-Link TL-WR841ND v10 ?
Posted: Fri Sep 16, 2016 6:12 pm
by Lantis
Pictures 1 and 2 show gateway mode which is correct assuming the devices are physically connected together correctly