Gargoyle Forum

I have recently installed gargoyle ispy, primarily so I can restrict quotas. When I view quota usage its blank though. Other "B/W Distribution" are showing graphs correctly though.

Device info:
1.9.X (Built 20160714-0844 git@9b75d12)
Model:TP-Link TL-WR1043N/ND v3

Can anyone help?

Also, my network here is quite complex and I'm not certain I can run my modem in bridge mode, I have however disabled DHCP on the modem and now only run DHCP on the Gargoyle. Everything seems okay, but interested in what others know about this scenario?

*bump*

Please provide your exact quota settings so we can see what might be wrong.

Hi Lantis, here are the two quota rules I have active.


Thank you

Have you done any tests? (other configs)


Final resort is do a failsafe reset

Just done some tests and mine works fine

After some thought you not going from LAN/WLAN to WAN (Firewall)

You need to plug the cables in the correct holes?

I'm not on site currently but my sister is so I can have her check, but I'm 99% certain the only cable I have connected is an ethernet to the WAN port. This cable connects to the LAN via a switch. Is this correct?

I should mention I have both web and ssh remote access.

*rebump*

You really have to go on site as see what happening

All else fail you will need to do a "failsafe reset"


I stated in the past the 50% of all problem are due to upgrading with "preserve setting" (the 50% was just a stab in the dark)

This maybe the case with your router?