Page 1 of 1
Linksys WRT1900ACv2
Posted: Fri Apr 29, 2016 8:02 pm
by dandersen
I got my new router today, and it's great... So I did some routing throughput testing (gigabit between lan and wan sides)...
Stock firmware
916/913
Gargoyle 1.9.0
899/753
Gargoyle 1.9.0 / QOS up and down set to 900 Mb
549/477
Very happy with this router and so happy to be with Gargoyle
Re: Linksys WRT1900ACv2
Posted: Fri Apr 29, 2016 11:19 pm
by Lantis
Nice! Good testing. i knew this router would be able to smash out the numbers.
Definitely goes to show how taxing routing every single packet is though!
Consider moving to 1.9.X to get the latest wifi driver for your device.
Re: Linksys WRT1900ACv2
Posted: Mon May 02, 2016 8:38 am
by dandersen
I will eventually... I want to run 2 weeks on 1.9.0 for a baseline comparison before deciding in an ispy build to use. I have no intention of using the Wi-Fi on this router, so am not in a big hurry in that regard.
Re: Linksys WRT1900ACv2
Posted: Tue May 03, 2016 8:25 am
by ericwong
dandersen wrote:Gargoyle 1.9.0 / QOS up and down set to 900 Mb
549/477
Can you enable bandwidth quota and use some very large quote, then see what performance you can get out of it?
In my test using Archer C7, bandwidth quota can result in higher performance drop than QoS, i.e. I only get ~40Mbps when I have bandwidth quota enabled with QoS, I get ~60Mbps with QoS without bandwidth quota. Without Quota and QoS, I can get >80Mbps. (Note: I tested it on an actual 100M internet connection.)
Re: Linksys WRT1900ACv2
Posted: Mon May 09, 2016 9:18 am
by dandersen
I'll try, but it might be a while. Once I've taken the router home, it's not as easy to for me run throughput testing.