Page 1 of 1
cant enable UPnP / NAT-PMP
Posted: Fri Mar 25, 2016 7:06 pm
by xpender
Hey,
some strange thig happens on WR841N v9, on 1.9.0.
I cannot enable UPnP / NAT-PMP.
It doesnt stays enabled after changes saved.
Could be a bug?
Re: cant enable UPnP / NAT-PMP
Posted: Fri Mar 25, 2016 7:32 pm
by Lantis
Upnp was removed from your router in 1.9.0 due to a space limitation.
4mb router support is basically all but over.
Re: cant enable UPnP / NAT-PMP
Posted: Sat Mar 26, 2016 3:23 am
by xpender
So, if downgrade to 1.8 it will work?
Re: cant enable UPnP / NAT-PMP
Posted: Sat Mar 26, 2016 3:25 am
by Lantis
Yes
Re: cant enable UPnP / NAT-PMP
Posted: Sat Mar 26, 2016 6:36 am
by xpender
ok, good enough for me.
Still, any chance to have wireless enabled by default after flashing new firmware?
I only have macbook pro without lan interface and every time I must beg the next door neighbor to borrow his ancient laptop to access my router via lan
Re: cant enable UPnP / NAT-PMP
Posted: Sat Mar 26, 2016 7:22 pm
by danymarc
Re: cant enable UPnP / NAT-PMP
Posted: Sun Mar 27, 2016 6:04 am
by xpender
yes, I am aware of that 10x
thread can be archived now
