Gargoyle Forum

Hi everyone,

I did a search on this but found many unanswered questions, so I thought I would ask again.

I am using a WZR-600DHP and I would like to use the 5ghz to wirelessly bridge to the 2.4ghz. I would then use the 2.4ghz as my wireless ap.

At present I can do this with DD-WRT but not Gargoyle. When I try to do it with Gargoyle it only allows me to do a wireless bridge on the 2.4ghz OR 5ghz, not connecting both.

Any ideas?

There is work underway to resolve this issue.

Very good. I look forward to the resolution.

Many thanks.

Muckaluck wrote:
I am using a WZR-600DHP and I would like to use the 5ghz to wirelessly bridge to the 2.4ghz. I would then use the 2.4ghz as my wireless ap.

At present I can do this with DD-WRT but not Gargoyle. When I try to do it with Gargoyle it only allows me to do a wireless bridge on the 2.4ghz OR 5ghz, not connecting both.

Any ideas?

I bet you can configure this manually using SSH/telnet.
It is probably supported by the Openwrt underneath but the Gargoyle web UI simply have not implemented the web interface.

Has anyone been able to figure this out?

I would like to set up a 5ghz wireless bridge and bridge with 2.4ghz

You can do this manually at the command line, but no it is not a feature you can configure by default.

thank you for the speedy reply!

I ended up using LEDE and setting up Client(WDS) + AP(WDS)