Page 1 of 1
How to back Gargoyle?
Posted: Fri Jan 01, 2016 9:41 am
by Doky
Hi!
TP-Link 1043ND V2 flashed V3 software..
How to back Gargoyle soft?
Re: How to back Gargoyle?
Posted: Fri Jan 01, 2016 2:16 pm
by nworbnhoj
Sorry, I am not clear about your question
Are you having trouble returning to the correct software for the V2? If you cannot simply reflash with the correct Gargoyle image then you may have to use on of the recovery methods.
http://www.gargoyle-router.com/wiki/dok ... e_recovery
Re: How to back Gargoyle?
Posted: Sat Jan 02, 2016 11:52 am
by Doky
nworbnhoj wrote:Sorry, I am not clear about your question
Are you having trouble returning to the correct software for the V2? If you cannot simply reflash with the correct Gargoyle image then you may have to use on of the recovery methods.
http://www.gargoyle-router.com/wiki/dok ... e_recovery
I have TP-Link 1043ND V2!
Flashed V3 TP-Link Original Software!
How to back flash Gargoyle FW?
Re: How to back Gargoyle?
Posted: Sat Jan 02, 2016 6:09 pm
by nworbnhoj
Doky wrote:I have TP-Link 1043ND V2!
Flashed V3 TP-Link Original Software!
How to back flash Gargoyle FW?
Ahhh - now I understand. That is an interesting problem.
If the V3 TP-Link Original Software actually runs then you might be able to Flash to Gargoyle with .....ar71xx-generic-tl-wr1043nd-v2-squashfs-
factory.bin
Otherwise I am guessing that you will need to use a serial cable to recover.