Gargoyle Forum

Just installed Gargoyle on my TPLINK AC1750 and tried to set up as a wireless adapter. I was able to scan and find my WIFI and enter password. Now I cannot even access gargoyle software or my WIFI via my TPLINK. Not sure if I can revert back to original firmware or how to even access my router. I'm not very savy with technology, was just trying to use my TPLINK as a faster wireless adapter than a USB plug in. I have ATT Uverse which uses a "modem" and a WAP. Any Help out there?
Thanks

If you can still access via an Ethernet cable then you can fix it easily.

Otherwise if it is inaccessible you'll need to do a failsafe reset.

How is a "fail safe reset" done?
thanks

https://wiki.openwrt.org/doc/howto/generic.failsafe

Trigger via hardware button is easiest.