Gargoyle Forum

Good morning from Germany, I have a question:

I would like to bind(fasten) a TP link WR1043ND V2 Router to an existing Router (Linksys E4200). The link TP Router should be responsible only for a NAS or a Satellite Receiver and appeal(speak) to this by GATE and a *.onion address. How do I realise the whole? Can somebody give me a tip? Maybe with LAN-to-WAN?
Thanks in advance
Fusswolf

This should not be too difficult but your description is a little unclear. Perhaps a picture would help!

Probably, I think that you will have a Gargoyle router Connecting to the Internet (via a satellite modem??) with it's WAN port. You will load the TOR plugin on the Gargoyle router. If your NAS offers a USB interface then it is very easy to publish a partition as a Tor Data Directory.

Alternatively if the NAS only offers a LAN connection, then you will probably want to connect the NAS to a Gargoyle LAN port and I suspect that you will need configure the Gargoyle firewall to forward requests on the TOR port thru to the NAS IP address. Should not be difficult, but I have not done this so I would need to fiddle around a little bit.