Gargoyle Forum

Page: Status -> Connected Hosts
Section: Connected Wireless Hosts

I would be an improvement if bitrate values are separated by upload/download.

Second improvement: a column with signal strenght in percentage, just beside the one with values in dBm.

It would be useful also to know which is the band (2.4 or 5 GHz) the devices are using; at the moment there's no way to know that.

It would also be nice to see, in that list, the Access Point / Main Router where the Gargoyle router is connected to (in case, of course, Gargoyle is connected via Wireless to main router); with of course signal strenght, bitrates and frequency used.

The last is very useful in case Gargoyle is connected via Wi-Fi to main router, because at the moment there's no way to know if Gargoyle router is actually connected or not to main router.

lollapalooza wrote:Page: Status -> Connected Hosts
Section: Connected Wireless Hosts

I would be an improvement if bitrate values are separated by upload/download.

It would be useful also to know which is the band (2.4 or 5 GHz) the devices are using; at the moment there's no way to know that.

Had an opportunity to implement both of these. Particularly the second suggestion is very useful.

Thank you!

Hi Lantis do you think it's possible to ad buttons next to devices to ad a static IP so it jumps you strate to the DHCP page?

tapper wrote:Hi Lantis do you think it's possible to ad buttons next to devices to ad a static IP so it jumps you strate to the DHCP page?

Nice idea, and not too hard, but better to wait until Known Devices is integrated because dhcp page changes somewhat.

If/when you have time, please consider also implementing the signal strength of the connection to the main router (in case Gargoyle is connected via WiFi to main router).

Can't see the time for the new stable version to come out