Gargoyle Forum

I am connected via LAN to WAN after installing gargoyle i am getting yellow triangle with exclamation mark on internet connection. I am very new in it but if you guide me i will make my way please help me..

I also did not take backup before installing Gargoyle of my tp link router. also tell me if i could go back to my previews tp link firmware from its site.

Please subscribe to my thread to help me I bought a brand new router only for gargoyle.

Thanks in advance

Hi there mate you will have to giv us a bit more info there. Like what modem do you have and how dus it connect to the inter net. what router do you have and whitch file did you use to flash. what lites are lit up on the frunt of your router? One thing you can try is to un plug your router and modem and then plug them back in to see if your router can then get a IP from your modem.

tapper wrote:Hi there mate you will have to giv us a bit more info there. Like what modem do you have and how dus it connect to the inter net. what router do you have and whitch file did you use to flash. what lites are lit up on the frunt of your router? One thing you can try is to un plug your router and modem and then plug them back in to see if your router can then get a IP from your modem.

I am using tp-link tl-wr740n ver 4.27 (only router not modem)

i flashed it with gargoyle_1.8.0-ar71xx-generic-tl-wr740n-v4-squashfs-factory.bin

i am trying to the internet using my (binatone 850w) MODEM > lan to my tplink WAN >and then tplink lan wire goes to my pc

before installing this i had a working connection in the above mode

see this image for litup in my router in my router instead of wirless lit lan lit work( as i have disablled wireless)

https://r00m.files.wordpress.com/2012/0 ... _front.jpg

NOTE:- I can go into my tp link router but not in my binatone modem when both are connected

i have changed my tp link router addresss to 192.168.1.10

and binatone modem to 192.168.1.50

(assuming that they may confilct each other if they have same router ips) as i am noob i tried it
please help

i am using win 7 please help

What connection mode are you using? PPPoE or DHCP?

Lantis wrote:What connection mode are you using? PPPoE or DHCP?

DHPC in tp Link

i think you'll have to put them on different subnets

Lantis wrote:i think you'll have to put them on different subnets

I had 255.255.255.0

I changed it to 255.255.0.0

Under Local Network / LAN in gargoyle

It did not work

I don't know if did right or not as i am new in it

nworbnhoj wrote:http://www.gargoyle-router.com/wiki/dok ... ario-modem

I tried exactly same setting to my tp Link but I am still getting yellow triangle