Page 1 of 1
TOR with TL-WR841ND
Posted: Thu Aug 20, 2015 4:27 am
by steve
I use a TP-Link TL-WR841ND. I installed the newest image of gargoyle. How can I install plugins or how I can route addresses to the "TOR"
Re: TOR with TL-WR841ND
Posted: Thu Aug 20, 2015 4:43 am
by ispyisail
Re: TOR with TL-WR841ND
Posted: Thu Aug 20, 2015 4:48 am
by steve
I think so. I have after installing no TOR button under Connection.
Re: TOR with TL-WR841ND
Posted: Thu Aug 20, 2015 4:56 am
by ispyisail
http://wiki.openwrt.org/toh/tp-link/tl-wr841nd
TP-Link TL-WR841ND
The device is a wireless N router with
2 detachable antennas
4 Port 100/10 Switch
1 Port 100/10 Wan Interface
4 MB Flash
32 MB Ram
QSS Button
Reset Button
Routers running Gargoyle 1.5.1 and above with a USB port have support Tor. It can be run on a router with 32MB of memory only if SWAP is enabled, but 64MB is recommended.
Recommended routers include
Ubiquiti Routerstation
Ubiquiti Routerstation Pro
Buffalo WZR-HP-G300NH
Netgear WNDR3700v1-2
Re: TOR with TL-WR841ND
Posted: Fri Aug 21, 2015 6:45 am
by steve
Ok since I've been saving at the wrong end. Now I bought a NETGEAR WNDR3700v5. Here are just're V2 Images offered. V5 also supports?
Re: TOR with TL-WR841ND
Posted: Fri Aug 21, 2015 7:21 am
by steve
Now I followed the recommendation and get V5 sent. When ordering you can not see or select. What now?
Re: TOR with TL-WR841ND
Posted: Fri Aug 21, 2015 7:52 am
by Lantis
it isn't supported.