Page 1 of 2
No access to server on Wifi
Posted: Sat Aug 01, 2015 12:37 pm
by Vjmcdonnell
I have just installed 1.6.2 on a TP Link WR1043N V1
All went well. I can access my Unraid Server when connected via wired but can't access it over Wifi. There is also the same issue with Internet, works on wired but not Wifi.
Any idea
Re: No access to server on Wifi
Posted: Sat Aug 01, 2015 5:18 pm
by nworbnhoj
Can you access the Gargoyle router from your wireless device? ie open Gaargoyle web interface at 192.168.1.1 or ping 192.168.1.1?
Re: No access to server on Wifi
Posted: Sat Aug 01, 2015 7:05 pm
by Vjmcdonnell
If I don't set a static ip on my android I get Internet but no access to server. If I set static ip I get server access but no Internet.
I'll just check gargoyle access
Re: No access to server on Wifi
Posted: Sat Aug 01, 2015 7:45 pm
by nworbnhoj
I suspect that you have Firewall setting in Gargoyle that are causing the issues. I suggest that you review your configuration under Gargoyle - Firewall - Restrictions & Quotas to find the source of the problem. Perhaps you might post screen shots of these two pages if you need some help.
Re: No access to server on Wifi
Posted: Sat Aug 01, 2015 7:49 pm
by Vjmcdonnell
I'll have a look and post back
Re: No access to server on Wifi
Posted: Sat Aug 01, 2015 10:10 pm
by ispyisail
double NAT?
network diagram please
Re: No access to server on Wifi
Posted: Wed Aug 05, 2015 4:34 pm
by Vjmcdonnell
Re: No access to server on Wifi
Posted: Wed Aug 05, 2015 5:24 pm
by nworbnhoj
In your Quota setup you are allowing each device a grand total of 20MB of data movement to/fro the internet.
Re: No access to server on Wifi
Posted: Wed Aug 05, 2015 5:28 pm
by Vjmcdonnell
After u mentioned them I only just set up that rule. Didn't make any difference though.
Re: No access to server on Wifi
Posted: Wed Aug 05, 2015 5:37 pm
by nworbnhoj
Suggest you disable or delete that rule and see if behaviour improves
