Gargoyle Forum

Hello,

I've done some googling and forums searches, and come up blank.

Basically I've installed the 1.6.2 x86 image onto a virtual machine in Hyper-V. That was the easy bit. The hard bit seems to be getting it to actually boot. Problem is it seems to be stuck on "Booting the kernel."

Currently all I have on my screen is:

Decompressing Linux... Parasing ELF... done.
Booting the kernel.

That's as far as it goes. Any thoughts?

I've also since tried 1.7.1, but it still stops in the same place. Doesn't continue.

Is this a known vault when running in Hyper-V? I've read that other people have used other visualization technology to run Gargoyle, so I would assume it works under Hyper-V?

where have you read this?

doing a forum search everyone is talking about compiling gargoye on hyper-v, but not running it on it.